Airbrush Motive 044 - Step 2

Adjust the pressure of the air compressor on 1.5 bar.

Note:

Use a respirator and pay attention that your workplace is enough ventilated.

Cut for preparation a piece paper strip. Take up the piece of the paper strip with the tweezers and hold it diagonally on the fingernail, similarly as right shown.

Use the airbrush pistol with the 0.4 mm nozzle. Fill into the paint cup two drops of the water soluble airbrush colour in white. The distance of the nozzle to the fingernail should be 2 or 3 cm, as right in the picture shown.

Pull the operating lever 3/4 back when spraying to regulate the colour. Press at the same moment the operating lever half down to regulate the air flow (double action principle), as right shown.

Move the airbrush pistol steady-going over the edge of the paper strip and the free fingernail surface.

The result should correspond approximately to the picture on the right side.

Put the paper strip on the left side of the fingernail and move the airbrush pistol steady- going over the edge of the paper strip and the free fingernail surface.

Now hold the paper strip with tweezers above the left fingernail tip and move the airbrush pistol steady- going over the edge of the paper strip and the free fingernail surface.

The result should correspond approximately to the picture on the right side.

Note:

Before you continue with step 3, wait until the sprayed airbrush colour on the fingernail is dried.