Airbrush Motive 124 - Step 4

Adjust the pressure of the air compressor on 1.5 bar.

Note:

Use a respirator and pay attention that your workplace is enough ventilated.

Use the airbrush pistol with the 0.3 mm nozzle. Fill into the paint cup a drop of the water soluble airbrush colour in red. The distance of the nozzle to the fingernail should be 2 or 3 cm, as right in the picture shown.

Pull the operating lever 3/4 back when spraying to regulate the colour. Press at the same moment the operating lever half down to regulate the air flow (double action principle), as right shown.

Start with the movement when spraying somewhat beside the fingernail. Move the airbrush pistol steady-going over the middle third of the fingernail.

The result should correspond approximately to the picture on the right side.

Note:

Before you continue with step 5, wait until the sprayed airbrush colour on the fingernail is dried.